force fed phase 1

I dream of running my dragbike on alky...mechanically injected. So I have a few bits that need some major mods to fit my shitshow, but first was trying to figure out how to run the pump. 

Plan is to maybe run the fire as a total loss with recharge in the pits, or even better a mag-neat-oh but thats a shitton more work and more money I don't have.... 

anyways, did some ciphering and figured out the ratios at the clutch shell that spins the alty and then back-figured what I needed to slow the pump down to half crank speed. 

off the shelf pulleys and a little XL belt may just do it.

or not.

Gordo Cooper wanted a window too.

Arts and crafts!

The whole show is transmitted thru setscrews

20 minute setup for a 2 minute pass

So, after a few belt lengths...

The alty shaft has been modifed to a hex too, to allow for external rotation or remote starting....

Sex change Pan / Shuv (Project Ayahuasca)

Here is a ridiculous amount of work condensed into a few seconds.

Fuggin' Dragbike

PCP BornFree 12 Shovelhead

Here's an neat stroker shovel I did

Project Ayahuasca- working backwards

Its been a minute, but this spot still is alive.....so am I, hope you are too. 

some non-van, make this fit that stuff....

1948 Right case from a friend that had a "mag-in-the-genny-hole" poorly done, 1974 alty case in reasonably good shape from a swapmeet
4 5/8" stroker wheel set with a 58 and up pinion shaft means the right case needs to be modded to fit the later 58 and up race
some boring work
then a chain drive with my outside mount setup with the integrated centrifugal advance